Mr. Plumber
Apr. 3rd, 2014 10:41 am![[personal profile]](https://www.dreamwidth.org/img/silk/identity/user.png){kind=small}
bluegargantuaHey,
So a few years ago I fixed the flapper in my toilet (the bit that clamps down and seals the tank so that water doesn't flow into the bowl). This was a serious leak that improved my water bill immensely when I fixed it.
Over the past year, my water bill has been inching up again. I know I'm probably using more water in general than I have in the past, but it still felt weird that it would be going up so consistently. Today, when I was cleaning the toilet, I realized that there was the hiss of water leaking. It could be that the flapper/seal is still faulty and is leaking, but I suspect that it might be the float because if I put my hand in the tank, that displaced enough water to raise the float a bit and stop the hiss.
It doesn't sound like the float is leaking or has water in it. Perhaps I need a new arm for the float with a better angle in it or something. Any ideas from the internet on how to troubleshoot this (to prove it's the float or the flapper) and what I could do about it (other than install new equipment, I expect to do that, but is there some trick of the trade I should be aware of)?
Thanks
Tom
So a few years ago I fixed the flapper in my toilet (the bit that clamps down and seals the tank so that water doesn't flow into the bowl). This was a serious leak that improved my water bill immensely when I fixed it.
Over the past year, my water bill has been inching up again. I know I'm probably using more water in general than I have in the past, but it still felt weird that it would be going up so consistently. Today, when I was cleaning the toilet, I realized that there was the hiss of water leaking. It could be that the flapper/seal is still faulty and is leaking, but I suspect that it might be the float because if I put my hand in the tank, that displaced enough water to raise the float a bit and stop the hiss.
It doesn't sound like the float is leaking or has water in it. Perhaps I need a new arm for the float with a better angle in it or something. Any ideas from the internet on how to troubleshoot this (to prove it's the float or the flapper) and what I could do about it (other than install new equipment, I expect to do that, but is there some trick of the trade I should be aware of)?
Thanks
Tom
